Logo

B2517 Engine Code Repair

Meaning of B2517 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B2517 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B2517 code is occuring now you should check B2517 repair processes.
Now don't ask yourself; What should you do with B2517 code ?
The solution is here :

B2517 Possible Solution:

B2517 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

B2517 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

5
O2 Sensor Heater Circuit Malfunction

1
Cold Start Injector 1 Malfunction

7
Ignition Coil A Primary/Secondary Circuit Malfunction

Regarding the B2517 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B2517 OBD-II Diagnostic Body (B) Trouble Code Description

B2517 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For B2517 Code

The reason of B2517 OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction.

B2517 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.